Stuck at Spalsh Screen

Post Reply
Posts: 1
Joined: Thu Mar 05, 2015 7:54 pm

Stuck at Spalsh Screen

Post by ljangler »

The FG085 I put together was working great for a couple of hours. It generated lovely sine waves square waves, triangle waves, etc. All of the buttons and modes functioned as expected.

Now while booting, it hangs on the third (?) splashscreen, the one that displays the firmware version.

Is there a way to reset the device or are there any troubleshooting steps I could take?
Site Admin
Posts: 8
Joined: Wed Feb 20, 2013 1:12 am

Re: Stuck at Spalsh Screen

Post by jyephpbb »

If the main firmware version shown is "08501-132" you can push the ADJ dial when the version screen appears at power-up. This will restore the factory default and fix the problem.
Post Reply