Last one for a while (certainly at least for this weekend
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
)
DSO_Shell_grabber_V1.7.4.zip
http://www.robocog.co.uk/electronics/ds ... V1.7.4.zip
This version:
Tested as working under XP SP3 and Windows 10 (I would assume all other flavors in between will work also)
Will detect available com ports and ask you to select which one you want it to use
It will write the settings to a file (comport.ini) so it won't have to bug you again
IF you need to change the com port (or if you made a typo) just delete the comport.ini before opening the app and it will ask again
or open and edit the comport.ini file and save it before opening the program
It will only create a single debug file - it will get overwritten each run of the program
It will wait forever till you hit V/DIV and ADJ buttons on the DSO Shell to start sending the data
It will grab the data and save it to all_data.txt - again it will get overwritten each run of the program
It will create a header.txt file - this shows the settings the scope was set to at the time of capture - it will get overwritten each run
The data from the above grabs gets formatted into a date and timestamped file (eg gnuplot 21-01-2018 16-52-23.txt) and a corresponding gnuplot file (dso150gnuplot 21-01-2018 16-52-23.plt)
These get created every run with a new date and timestamp - so the folder may get busy! (but you can refer back to them later)
It will then attempt to open gnuplot and stay open asking if you want to run it again
If you want to run it again and take another plot , just hit enter
If you want to quit press q and hit enter
Any questions or requests - give me a shout
Regards
Rob