I just put together an FG085 function generator. When I turn it on, I'm (usually) unable to change anything. Occasionally I can change the wave type, but I usually cannot. I've read that this could be a problem with the installation of buttons. I checked them all, and they all seem to be correct. They don't seem to be shorted when not pressed, and when I press them, the correct two terminals are shorted.
Any advice would be greatly appreciated.
FG085 button(?) issue
Re: FG085 button(?) issue
Did the [ADJ] dial work?
-
- Posts: 3
- Joined: Fri May 30, 2014 9:20 pm
Re: FG085 button(?) issue
Yes, the dial works to change the frequency.
Re: FG085 button(?) issue
Please remove the front panel and test again. Some buttons may not be able to bounce back freely due to friction.