Support for 10x (and maybe 100x) probes
Posted: Wed Oct 30, 2019 3:00 pm
Hello,
when i use Wave2 with 10x (or 100x) probe, the displayed voltage is 10x or 100x lower than in reality (because of probe attenuation). This is to be expected, but i think it would be nice to be able to change wave2 settings to multiply the voltage in software for me. So i don't have to remember to multiply the measured voltage 10x myself all the time. This should be setting available separately for each channel.
when i use Wave2 with 10x (or 100x) probe, the displayed voltage is 10x or 100x lower than in reality (because of probe attenuation). This is to be expected, but i think it would be nice to be able to change wave2 settings to multiply the voltage in software for me. So i don't have to remember to multiply the measured voltage 10x myself all the time. This should be setting available separately for each channel.