Page 1 of 1
Have to press & hold [+] and [-] each time after power cycle
Posted: Wed Jan 16, 2019 10:30 pm
by Loenie
Few weeks ago I received and assembled the kit, which came pre-loaded with firmware 113-13810-100 and worked as expected.
I then updated to firmware 113-13810-110 and since then I have to press and hold [+] and [-] for a few seconds after each power cycle in order to get it to work. The unit boots and runs fine, but does not process any input signal; it behaves like it is set to GND-coupling or so.
Re: Have to press & hold [+] and [-] each time after power c
Posted: Mon Jan 21, 2019 5:00 pm
by jye1
Can you post photos showing the issue please?
Re: Have to press & hold [+] and [-] each time after power c
Posted: Mon Jan 21, 2019 8:15 pm
by Loenie
Hi,
See
https://youtu.be/lHrNWvwiXlI for a self-explaining vid.
This behaviour is regardless of the setting of any of the slide switches or the type of input signal.
Thanks for your time!
Re: Have to press & hold [+] and [-] each time after power c
Posted: Sun Feb 17, 2019 10:26 am
by Loenie
Hi,
Have you got any update on this issue pls?
Thx.
Re: Have to press & hold [+] and [-] each time after power c
Posted: Tue Feb 19, 2019 1:36 pm
by jye1
Sorry no update. There might be something related to the chip. Have you tried roll back to version -100 and see if the problem is still there?
Re: Have to press & hold [+] and [-] each time after power c
Posted: Fri Feb 22, 2019 8:46 pm
by Loenie
I couldn't try, because I don't have a copy of version -100 and I can't find it on your website ...
Re: Have to press & hold [+] and [-] each time after power c
Posted: Sat Feb 23, 2019 12:30 pm
by jye1
Re: Have to press & hold [+] and [-] each time after power c
Posted: Sun Feb 24, 2019 8:55 am
by Loenie
Hi,
Rolled back to version -100 and now it works again properly!
Also no more on-screen flashing jyetech add
Thx
Re: Have to press & hold [+] and [-] each time after power c
Posted: Sat Dec 21, 2019 3:14 pm
by smokok
Я решил эту проблему по другому без перепрошивки. Перейти в режим "Int" и удержать более секунды кнопку "ОК" и пройти тест. Важно!!! Щуп должен быть подключён к тест контакту!