Page 1 of 1
Counterfeit 062?
Posted: Tue Aug 16, 2016 3:41 am
by mwm
On looking at my 062 kit, the LCD module does not have any signal labels on it, just pin 1 on one side. Could this be a counterfeit?
Re: Countries 062?
Posted: Tue Aug 16, 2016 1:55 pm
by jye1
Can you post photo showing the board?
Re: Counterfeit 062?
Posted: Tue Aug 16, 2016 9:45 pm
by mwm
Ok, I've attached images of the component side of both the LCD module and the main board.
Re: Counterfeit 062?
Posted: Thu Aug 18, 2016 2:40 am
by jye1
Thank you for the photos. This board doesn't look counterfeit. The LCD was from a different supplier and has different markings.
Re: Counterfeit 062?
Posted: Thu Aug 18, 2016 5:24 am
by mwm
In that case, I think I have a dead lcd module. It doesn't light up at all. I'll post voltages tomorrow, but most of them seemed ok, though many were 1 volt higher than listed, which I assume is because I use a 10 volt ps.
But for now, which side should the 20 pin header be attached to? The assembly instructions say the side with the signal labels, but this module has no signal labels on it, just the two pin numbers 1 and 20.