Counterfeit 062?

Post Reply
mwm
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm

Counterfeit 062?

Post by mwm »

On looking at my 062 kit, the LCD module does not have any signal labels on it, just pin 1 on one side. Could this be a counterfeit?
Last edited by mwm on Tue Aug 16, 2016 9:59 pm, edited 2 times in total.
jye1
Posts: 1227
Joined: Wed Feb 20, 2013 4:58 pm

Re: Countries 062?

Post by jye1 »

Can you post photo showing the board?
mwm
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm

Re: Counterfeit 062?

Post by mwm »

Ok, I've attached images of the component side of both the LCD module and the main board.
Attachments
main board
main board
LCD module
LCD module
jye1
Posts: 1227
Joined: Wed Feb 20, 2013 4:58 pm

Re: Counterfeit 062?

Post by jye1 »

Thank you for the photos. This board doesn't look counterfeit. The LCD was from a different supplier and has different markings.
mwm
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm

Re: Counterfeit 062?

Post by mwm »

In that case, I think I have a dead lcd module. It doesn't light up at all. I'll post voltages tomorrow, but most of them seemed ok, though many were 1 volt higher than listed, which I assume is because I use a 10 volt ps.

But for now, which side should the 20 pin header be attached to? The assembly instructions say the side with the signal labels, but this module has no signal labels on it, just the two pin numbers 1 and 20.
Post Reply