It is possible to adjust the capacity of C3, but not C5.

Post Reply
User avatar
moyaelectronnka
Posts: 1
Joined: Sun Oct 06, 2019 3:00 pm

It is possible to adjust the capacity of C3, but not C5.

Post by moyaelectronnka »

Hello. When setting up the oscilloscope at a level of 0.1 volts with a capacity of C3, everything is fine. However, after switching the test signal to 3.3 volts, problems begin: with an increase in sensitivity, the beam disappears from the screen. What could be the reason?
Thanks.

Image
Post Reply