Hello!
On the oscilloscope board, you can (optionally) install a 9 volt power connector. Since I'm going to use this to power the transistor tester, I want to ask:
- what type of plug is needed for this connector (see photo);
- What is the best way to make a hole in the oscilloscope body for this? Maybe there are overall dimensions? Or can someone measure them on another version of the constructor? Thanks.
Type of plug for backup power and hole values in the housing
Type of plug for backup power and hole values in the housing
Motherboard: PN:109-15000-00E2
Analog board:PN: 109-15001-00F
Analog board:PN: 109-15001-00F