Page 1 of 1
T. S. Amp?
Posted: Mon Aug 20, 2018 7:12 pm
by EdRington
I just got my Shell, and the display always(?) shows the following in the lower left corner:
T. S. Amp: 3.3v
What does that mean, and how I remove it? The little one page User Manual is not very helpful.
Thanks.
Re: T. S. Amp?
Posted: Mon Aug 20, 2018 9:59 pm
by EdRington
OK. I figured out that it is the Test Signal voltage, and can change it by pressing the adj button. However, the display still won't go away???
Re: T. S. Amp?
Posted: Tue Aug 21, 2018 1:54 pm
by jye1
The display can be turned on or off by holding down ADJ dial.
Re: T. S. Amp?
Posted: Tue Aug 21, 2018 2:12 pm
by EdRington
Pressing the adj knob does enable/disable the display of times and voltages, but does not remove the "T. S. Amp=3.3V" readout.
Re: T. S. Amp?
Posted: Tue Aug 21, 2018 2:14 pm
by EdRington
You are correct. I held it down longer and the "T.S. Amp=3.3v" disappeared. Thanks.