T. S. Amp?

Post Reply
EdRington
Posts: 6
Joined: Thu Aug 16, 2018 2:43 pm

T. S. Amp?

Post by EdRington »

I just got my Shell, and the display always(?) shows the following in the lower left corner:

T. S. Amp: 3.3v

What does that mean, and how I remove it? The little one page User Manual is not very helpful.

Thanks.
EdRington
Posts: 6
Joined: Thu Aug 16, 2018 2:43 pm

Re: T. S. Amp?

Post by EdRington »

OK. I figured out that it is the Test Signal voltage, and can change it by pressing the adj button. However, the display still won't go away???
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: T. S. Amp?

Post by jye1 »

The display can be turned on or off by holding down ADJ dial.
EdRington
Posts: 6
Joined: Thu Aug 16, 2018 2:43 pm

Re: T. S. Amp?

Post by EdRington »

Pressing the adj knob does enable/disable the display of times and voltages, but does not remove the "T. S. Amp=3.3V" readout.
EdRington
Posts: 6
Joined: Thu Aug 16, 2018 2:43 pm

Re: T. S. Amp?

Post by EdRington »

You are correct. I held it down longer and the "T.S. Amp=3.3v" disappeared. Thanks.
Post Reply