The Main board has test points for the SENSEL states, but they're only accessible if the Analog board is disconnected. It appears the SENSEL states are independent of the Analog board ( http://www.jyetech.com/forum/viewtopic. ... 1108#p3510 ), is this correct?
In which case, I can disconnect the two boards and still get accurate readings?
Thanks,
John
Testing SENSEL 0/1/2/3 ?
Re: Testing SENSEL 0/1/2/3 ?
The SENSEL0-3 signals are sent from main board to analog board.
Re: Testing SENSEL 0/1/2/3 ?
I'll take that as a "yes". Thanks.