OK, got a new kit from same seller as my first. I solder the main board and put on my old analog board from the first kit. And it did work instantly.
So no Q, the first main board was defect.
No trace
Re: No trace
Where did you get the DSO from?swed wrote:OK, got a new kit from same seller as my first. I solder the main board and put on my old analog board from the first kit. And it did work instantly.
So no Q, the first main board was defect.
I seem to have problems with my unit too. Something with the STM32 isnt right I think.
Cannot get a proper Trace. So as last I decided maybe it is a buggy firmware. Trying to get v 55 Firmware flashed, but the STM32 doesnt get recognized by the CP2102. Although I jumped both Jumpers.
So this sounds like a defective Motherboard too.
Could you get any signal? Like when touching the center of the BNC with tweezers, as it says in the FAQ?
Re: No trace
Ebay, http://www.ebay.co.uk/itm/351880512929? ... EBIDX%3AIT
Don't know what was wrong with the first but it might been the cpu.
Don't know what was wrong with the first but it might been the cpu.