DSO 150 (Shell) Check Voltage and more
Posted: Thu Nov 10, 2016 7:20 am
Good morning Sirs,
Just received the 15001K Kit. Solder the components, test the boards, done the probe calibration and did some simple sine wave experiments. It seems to work well.
Firmware: 113-15001-050
When testing the voltages (SW1 set to GND) I realized that V4 is +1.5V and not +1.61V as you mentioned in the manuals (V6 not mentioned is 6.0V). Checking R13, R14 and R15 does not show any faults. Factory reset does not change the voltage. But doing measurements with the scope seems to work well.
So, any comments on this are appreciated.
Furthermore I would be interested if it´s possible to connect the device via the TX/RX Pins on the board with a PC and use your software to process and display the data.
Thanks for your comments
Just received the 15001K Kit. Solder the components, test the boards, done the probe calibration and did some simple sine wave experiments. It seems to work well.
Firmware: 113-15001-050
When testing the voltages (SW1 set to GND) I realized that V4 is +1.5V and not +1.61V as you mentioned in the manuals (V6 not mentioned is 6.0V). Checking R13, R14 and R15 does not show any faults. Factory reset does not change the voltage. But doing measurements with the scope seems to work well.
So, any comments on this are appreciated.
Furthermore I would be interested if it´s possible to connect the device via the TX/RX Pins on the board with a PC and use your software to process and display the data.
Thanks for your comments