Can't upgrade to 060 firmware
Can't upgrade to 060 firmware
I get "no response from target" error using Banggood TTL/Serial converter board (PN 970993 which uses CP2102 chip) with driver. My DSO138 is genuine board, I've followed jye upgrade procedure, tried swapping TX/RX lines, everything I can think of. Am I missing something?
Re: Can't upgrade to 060 firmware
Did you choose the right com port? Remember JP1 and JP2 need to be closed.
-
- Posts: 20
- Joined: Tue Dec 15, 2015 12:06 pm
Re: Can't upgrade to 060 firmware
Yes, read this : http://wwww.jyetech.com/forum/viewtopic ... P2102#p924Zep wrote:I get "no response from target" error using Banggood TTL/Serial converter board (PN 970993 which uses CP2102 chip) with driver. My DSO138 is genuine board, I've followed jye upgrade procedure, tried swapping TX/RX lines, everything I can think of. Am I missing something?
And then this : http://wwww.jyetech.com/forum/viewtopic.php?f=18&t=748
Best regards,
boby
Re: Can't upgrade to 060 firmware
I closed JP1 and JP2, used correct COM port, bypassed R33, tried my Arduino Uno, swapped RX/TX and still nothing works. DSO138 TX line will not drop below about 2 volts when I click NEXT. I have traced TX and RX lines to chip, no shorts or low resistance and cleaned the board. I give up unless jyetech can supply a list of adapters PROVEN to work with the DSO138. Thanks for the help.
Zep
Zep