Can't upgrade to 060 firmware

[Zep]

I get "no response from target" error using Banggood TTL/Serial converter board (PN 970993 which uses CP2102 chip) with driver. My DSO138 is genuine board, I've followed jye upgrade procedure, tried swapping TX/RX lines, everything I can think of. Am I missing something?

[jye1]

Did you choose the right com port? Remember JP1 and JP2 need to be closed.

[bobydunkel]

I get "no response from target" error using Banggood TTL/Serial converter board (PN 970993 which uses CP2102 chip) with driver. My DSO138 is genuine board, I've followed jye upgrade procedure, tried swapping TX/RX lines, everything I can think of. Am I missing something?

Yes, read this : http://wwww.jyetech.com/forum/viewtopic ... P2102#p924

And then this : http://wwww.jyetech.com/forum/viewtopic.php?f=18&t=748

Best regards,
boby

[Zep]

I closed JP1 and JP2, used correct COM port, bypassed R33, tried my Arduino Uno, swapped RX/TX and still nothing works. DSO138 TX line will not drop below about 2 volts when I click NEXT. I have traced TX and RX lines to chip, no shorts or low resistance and cleaned the board. I give up unless jyetech can supply a list of adapters PROVEN to work with the DSO138. Thanks for the help.
Zep

[daveh]

This CP2102 adapter works for me.

http://r.ebay.com/tiZEBQ