We have just made the version -050 firmware available for downloading on jyetech.com. Since it can not protect us we have no reason to continue the hurts to our customers. JYE Tech sincerely apologizes for these hurts caused by holding the firmware and appreciates all understandings and supports. We will continue to create better performance, higher quality, and more affordable products for our customers.
To download the firmware please visit: http://www.jyetech.com/Products/LcdScope/e138.php
New kits - 13803/4K - F/W .050
-
- Posts: 58
- Joined: Sat Jun 06, 2015 9:06 am
Re: New kits - 13803/4K - F/W .050
Thank you very much!
Re: New kits - 13803/4K - F/W .050
Thank you for doing this. No need to apologise - you were just trying to protect your intellectual property which is perfectly understandable.
I hope you win your battle with the counterfeiters. I have a number of Jyetech products and have enjoyed making/using them along with access to the great support you provide.
Carry on the good work!
Andy
I hope you win your battle with the counterfeiters. I have a number of Jyetech products and have enjoyed making/using them along with access to the great support you provide.
Carry on the good work!
Andy
Re: New kits - 13803/4K - F/W .050
I would like to thank you for making this available. I had trouble with my new units firmware failing and I put in the old firmware. I will now update it. I also have one of the older units. Is there any reason not to update it? Can I update the older unit I purchased from your supplier with out any problems? Do I need to change the hardware on the older unit?
Thanks again for listening to all of us complain about not being able to update to the new firmware, with out you just giving up on all of us.
Have a nice weekend.
Thanks again for listening to all of us complain about not being able to update to the new firmware, with out you just giving up on all of us.
Have a nice weekend.
Re: New kits - 13803/4K - F/W .050
To work with the -050 firmware the only hardware change is to replace R11 (which was a 1.5K resistor) with a 150 ohm resistor. No other change is required.
Re: New kits - 13803/4K - F/W .050
jye1:
Thanks again for allowing us to update with the newest firmware and thanks for the information on the hardware update.
Have a nice week.
Don
Thanks again for allowing us to update with the newest firmware and thanks for the information on the hardware update.
Have a nice week.
Don
Re: New kits - 13803/4K - F/W .050
First of all thank you very much JYE1 for taking this decision. I am sure you will have returning customers on all of your products. I for one will be buying your FG085 function generator this week..it is being sold here in Montreal Canada by Abra Electronics.
Questions about the new firmware and the noise reduction modification I made to my board. What will be the impact of the noise reduction modification? Should I revert back to the standard connection of my board or will the noise reduction modification still improve the signal noise?
Thanks again.
Questions about the new firmware and the noise reduction modification I made to my board. What will be the impact of the noise reduction modification? Should I revert back to the standard connection of my board or will the noise reduction modification still improve the signal noise?
Thanks again.
Re: New kits - 13803/4K - F/W .050
The hardware mod is still valid for the new firmware even though you might not be able to feel the improvement. It is recommended to keep the mod.
Re: New kits - 13803/4K - F/W .050
Could you tell me if the 150 ohm resistor R11 is 1/4 or 1/8 watt?
Thanks
Thanks
Re: New kits - 13803/4K - F/W .050
It doesn't matter. Factory provided was 1/8W.