Page 1 of 1

confirm maximum voltage input

Posted: Mon May 25, 2020 12:34 pm
by kittysoman2013
i am going to be using this scope to see audio signals and prevent clipping from 0.1V through 150V amps and signal generators/processors. the bone stock max voltage is 50vpk correct? so that will give me 25V blow ground floor and 25v above for AC sine, would this scope be able to handle 35V stock? the math would say 35V rms would be the maximum true sine wave displayed and 25 volt for a square wave correct?

if i run a X10 probe i would then have a maximum of 500V that this scope can display correct?