Hello JYE Tech,I am new here.
I am owner of DSO112 oscilloscopes.
I purchased DSO112 about 1 month ago, maybe last on in warehouses, and I found it so good for my hobby that I ordered an other .
Next one is already DSO112A Coral (FW: 113 11201 210, TS11201-120). I recieved it on Apr. 4. 2016.
Sadly the Coral exhibits problem. After switchover vertical sensitivity or timebase and touch key "done" reboots itself immediately, sometime to main working state with default parameters, sometime to unstable state (a flashing blank white display). The problem persists even on fully charged battery or USB power. Maybe problem with FW ?
I want to try download new FW, but on jyetech.com is only (older?) version 113 11201 200.
Thank you in advance for your advice.
Jiri
DSO112A Coral
Re: DSO112A Coral
Have you tried factory default restore? Please do it if you haven't.
Re: DSO112A Coral
Yes, tried. Even three times in a row. Without effect.
And Coral reboots after „done“ even if in reality no change Y-sensitivity or timebase value was done.
Work in "Trigger mode", "Menu", "Set up screen" etc. is OK.
Jiri
Czech Rep.
And Coral reboots after „done“ even if in reality no change Y-sensitivity or timebase value was done.
Work in "Trigger mode", "Menu", "Set up screen" etc. is OK.
Jiri
Czech Rep.
Re: DSO112A Coral
Please try reflashing the attached new firmware.