I am having trouble with my new DSO 112 getting it to trigger properly in the "Single Trigger mode when the timebase is set to a value less than (faster than) 10 usec/div. At 10 usec/div or above it seems to work correctly. At 5 usec/div or below, the scope triggers, but continues to accept triggers (not going into the Hold mode).
Any suggestions?
Thanks.
DSO112 Trigger Issue
Re: DSO112 Trigger Issue
What you observed was true and normal. When timebase is set to 5us/div or smaller MCU uses highest sampling rate and, as result, can't handle triggers. Please see http://www.jyetech.com/Products/LcdScop ... es_112.php.