Some observations -
1) Using your test signal at 100 Khz, time base 1 uS or 2 uS or 5uS display will not be stable.
Only when selected 10 uS or higher will I get a stable display. Waveform 7 divisions high,
vert at .5 Vdc, Normal triggering
2) Using your test signal at 100 Khz, time base 1 uS, trying to see leading edge of test signal,
I should see 5 Mhz sample rate / 100 Khz signal = 50 samples. I see no stable display.
3) Using test signal at 1 Mhz, Tektronix 1 GS/sec scope TDS754A, 10X probe compensated
on Tek scope, I see not a square wave but a severely distorted RC rise and fall waveform.
Why is this not a high drive CMOS output on the processor ? So thats its square ?
4) Using your 1 Mhz test signal the DSO112A will not trigger at any timebase setting ? It has
5 Mhz sample rate, why is it not triggering at all.
5) How do I tell what version of firmware I have ? What DSO112A screen is it stated on ?
6) Any plans to upgrade with signal averaging, envelope mode, and FFT ? Signal averaging (noise reduction)
the most important, followed by envelope (jitter measurements) followed by FFT for spectrum studies.
Regards, Dana.