[DSO112A] Input terminals with 2.4v

Color oscilloscope with touch panel
Post Reply
FelipeLacerda
Posts: 1
Joined: Sat Jul 24, 2021 4:40 am

[DSO112A] Input terminals with 2.4v

Post by FelipeLacerda »

After being unused for a month, this voltage of approximately 2.4v DC appeared at the input terminals.
Any suggestions from friends?

When switching between AC/DC/GND couplings, you can hear the relay switching, so I assume it's OK.
With GND coupling the measurement is correct (0v).
With cables connected the values are the same.
Attachments
dso112a.jpg
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: [DSO112A] Input terminals with 2.4v

Post by jye1 »

Please try executing VPos alignment in the menu. This appeared to be a VPos offset mismatch. The scope should be fine.
Post Reply