Page 1 of 1
Bad Crystal
Posted: Fri Jul 08, 2016 9:37 pm
by adam
I received a bad crystal with my DSO 068 kit. I spent a good bit of time trying to figure out why the last step of the initial power up test was failing. I took a 20MHz crystal out of an old linksys router and it booted right up. Is there a process to get a replacement?
Re: Bad Crystal
Posted: Sat Jul 09, 2016 5:31 am
by jye1
Please connect JYE Tech at
jyetech@163.com
Re: Bad Crystal
Posted: Tue Nov 01, 2016 12:08 pm
by WolfgangHOME
I also had a bad crystal resulting in a failed powering-up test 1. When I replaced the crystal the test was passed successfully. Look slike this is a critical bad quality component.
Re: Bad Crystal
Posted: Tue May 30, 2017 10:08 am
by Godwyn74
In my setup, the powerup test faild where the led needed to flash.
I replaced the crystal when i came across this topic:
SUCESS!
Everything is fine now. Fun to assemble. Great Kit!
Re: Bad Crystal
Posted: Fri Feb 22, 2019 12:38 pm
by FalloutBe
Same story here.
Replacing the crystal did the trick
Re: Bad Crystal
Posted: Tue Apr 30, 2019 4:12 pm
by cpprioli
Interestingly, mine too failed the power-up test and I tracked the issue to the crystal by process of elimination. I then removed and re-installed the crystal and all was well. IDK why this happens, as the crystal was properly installed the first time. All that I know is that removing and re-soldering it solved the failure issue. Now I want to upgrade the main firmware to the newest level, if I can find English instructions...
