The unit worked fine for several months after construction but now is faulty.
It appears to boot up ok but then the display is frozen. The backlight can be toggled and the rotary encoder will switch it on or off but nothing else works.
Any ideas?
I have already flashed the latest firmware.
https://www.youtube.com/watch?v=sUUghhsp8WQ
Frozen!
Re: Frozen!
Can you post a photo showing the screen?
Re: Frozen!
Please follow the link to my youtube video. At 12 seconds you will see the frozen screen.jye1 wrote:Can you post a photo showing the screen?
It is stuck on fft mode.
That was the last mode I used it for.
Unit does not respond to anything but power on, power off and display light toggle.
Re: Frozen!
I am sorry. Youtube is blocked in China. We can't open it.
Re: Frozen!
Hi
Sorry to hear that you cannot get youtube.
Here is a photo:
Best regards
Sorry to hear that you cannot get youtube.
Here is a photo:
Best regards
Re: Frozen!
I have attached a photo to an email and sent it to jyetech@gmail.com
Re: Frozen!
I hope you can see the image now, I am running out of ideas.
If you can see the image then I could try to send you the video that is on youtube.
Best regards
If you can see the image then I could try to send you the video that is on youtube.
Best regards
Re: Frozen!
I received this reply from Zemin at JYE:
"Hi, please try the following to perform forced factory default restore.
1 ) Connect the pad PF6 at J7 to GND.
2 ) Power up the device until you see normal scope panel.
3 ) Remove the connection made in 1 )."
This worked and the oscilloscope is now functioning normally.
Re: Frozen!
The unit still freezes when you try to use fft mode, also it randomly freezes completely now in a state where it will not even turn off and the backlight switch does not work.
Somebody has replied to my post on youtube saying that they have the same issue and it is a firmware problem.
Somebody has replied to my post on youtube saying that they have the same issue and it is a firmware problem.