Hello! After the assembly is not working. all voltages are normal. Except V5-3.36 v. Led does not shine when you click SW12. There is no image on the display. There is no backlight.
I think not OK U4 Atmega64. When connecting the programmer to the U4 is not read.
How to Flashing after replacing Atmega64 to a new one?
Does not work
Re: Does not work
Please try replacing crystal first if you can. Firmware is available at www.jyetech.com.
Re: Does not work
how to program? first program loader, then the firmware? both in HEX.
Crystal replaced in the near future. which bits aree set?
Crystal replaced in the near future. which bits aree set?
Re: Does not work
Hello! After replacing a replacement and firmware new Atmega64 oscilloscope earned. Program "eXtreme Burner", the programmer "USBASP". Installing the fuse bits, specified in the User Manual is mandatory.