Forced factory default restore

[jye1]

Sometimes DSO068 might be found behaviors abnormally (like constantly rebooting, halt in a specific state) and menu can't be entered to perform factory default restoration. In this case you can do forced factory default restore by following steps below:

1 ) Power off the scope and connect PF6 pin at J6 to GND via a 1K resister.
2 ) Power up device to normal working state.
3 ) Power off device and removed the connection made in 1 ).

[Clint]

When I look at my board, and schematic, I see PF6 on J7, not J6. Should that be J7?

[jye1]

Yes PF6 is on J7 instead of J6. Sorry for the mistake.

[Clint]

Thanks. Worked great.