JYE TECH DSO 068 O-SCOPE NOT WORKING

Anything about this unique oscilloscope DIY kit
Post Reply
ChuckC
Posts: 2
Joined: Mon Jan 06, 2020 12:09 am

JYE TECH DSO 068 O-SCOPE NOT WORKING

Post by ChuckC »

I haven’t been able to get my new DSO 068 oscilloscope working yet. I’ve gone through all the voltage checks and they are all okay.
D1, LED turns on when power is applied and the beeper sounds. D1 is on for about a half second then turns off for about 3 seconds before a short flash. Then a half second later, D1 cycles at one second on and one second off continuously.
Also, when power is applied, the display background illuminates for about 3 seconds. Probing test point SYSCLK with my DMM can cause the on/off cycling of D1 to stop and the display to read: Boot Loader, Ver: 113-06803-020, JYE Tech. LEVEL button can turn the background on and off in this scenario.
Do you have any suggestions for solving this problem. Also, BOB 3 (JYE 117) does not work but I have JP2 jumpered.
Thank you for any help you can provide.
ChuckC
ChuckC
Posts: 2
Joined: Mon Jan 06, 2020 12:09 am

Re: JYE TECH DSO 068 O-SCOPE NOT WORKING

Post by ChuckC »

A technician at jyetech@163.com informed me that JP8 was shorted. I removed the inadvertent short and that solved my problems. ChuckC
Post Reply