Hello. I have a question. Is there any possibility to calibrate voltage level reported by scope? My measuring. All done using internal signal generator:
Signal level 5vpp @ 1kHZ
1V x1 - 5,57V
1V x2 -5,60V
1V x5 - 5,67V
Signal level 3vpp @ 1kHZ
1V x5 - 3,33V approx.
1V x1 - 3,33V
0,1v x5 -2,95V
Signal level 1vpp @ 1kHZ
0,1V x2 - 1,10V
0,1 V x5 -1,08V
Signal level 0,3vpp @1kHZ
0,01v x5 - 0,315V
0,1V x2 - 0,31V
Is there any possibility to calibrate these values especially when 1V per div is selected? Many thanks in advance