not respond to commands from buttons

Anything about this unique oscilloscope DIY kit
Post Reply
rolonol
Posts: 1
Joined: Mon Jan 30, 2017 8:43 am

not respond to commands from buttons

Post by rolonol »

Dependency in one of the modes, and prisoners again falls into the same mode and there is no opportunity to go to the main menu! How can this problem be solved? Firmware for usb has not helped. Is there a reset to factory settings by holding any buttons?
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: not respond to commands from buttons

Post by jye1 »

Please try the following to restore factory default.

1 ) Connect the pad PF6 at J6 to GND.
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."
jaxllax
Posts: 15
Joined: Thu Jun 15, 2017 3:08 pm

Re: not respond to commands from buttons

Post by jaxllax »

amigo mire el minuto 3.36 en adelante
https://www.youtube.com/watch?v=2oniUUqrxUY
clear eeprom 1k resistor
The connectors involved are any GND and PF6 connector J7= (gnd = j5 ) y ( PF6 = J7
1 ) Connect the pad PF6 J7 at J5 to GND. 1k resistor
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."
Post Reply