not respond to commands from buttons
not respond to commands from buttons
Dependency in one of the modes, and prisoners again falls into the same mode and there is no opportunity to go to the main menu! How can this problem be solved? Firmware for usb has not helped. Is there a reset to factory settings by holding any buttons?
Re: not respond to commands from buttons
Please try the following to restore factory default.
1 ) Connect the pad PF6 at J6 to GND.
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."
1 ) Connect the pad PF6 at J6 to GND.
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."
Re: not respond to commands from buttons
amigo mire el minuto 3.36 en adelante
https://www.youtube.com/watch?v=2oniUUqrxUY
clear eeprom 1k resistor
The connectors involved are any GND and PF6 connector J7= (gnd = j5 ) y ( PF6 = J7
1 ) Connect the pad PF6 J7 at J5 to GND. 1k resistor
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."
https://www.youtube.com/watch?v=2oniUUqrxUY
clear eeprom 1k resistor
The connectors involved are any GND and PF6 connector J7= (gnd = j5 ) y ( PF6 = J7
1 ) Connect the pad PF6 J7 at J5 to GND. 1k resistor
2 ) Power up the device until you see normal scope panel.
3 ) Power off and remove the connection made in 1 )."