Page 1 of 1
Installation guide for JYELAB 70
Posted: Wed Jan 27, 2016 5:31 pm
by termin
I have WIN 10, can,t find installation file for jye Lab 70 program in dokumentation,
Question this program working in WIN10?
Re: Installation guide for JYELAB 70
Posted: Thu Jan 28, 2016 4:27 pm
by jye1
jyeLab doesn't need to install. Just copy all files to one folder and run the exe file. It is not tested on Windows 10. But it is reported not working very well for Windows 7 and later.
Re: Installation guide for JYELAB 70
Posted: Sat Jan 30, 2016 3:55 pm
by termin
Thank you, I have installation driver CP, JYELAB program, connected DSO 068 to USB port, PC acknowledged USB port, but DSO 068 in Oscilloscope mode not going in USB mode, not any reactions,
I make control all components R24, R25 and connection from 119 panel 6, 7 ports to U4 2 and 3, make output bridge 6 and 7 ports, connected its, not reaktions.
May be wrong 119 panel? or soldering no good?
Re: Installation guide for JYELAB 70
Posted: Wed Feb 03, 2016 1:41 am
by jye1
Did you see the virtual serial port from inside jyeLab? Please go to Options->Port Setup and do a ReScan. Then click the dropdown box to find the port corresponding to DSO068. Set baudrate to 115200 and click OK. At the main panel of jyeLab click Connect button. 068 will should USB Scope Mode if it receives request from jyeLab.