jyeLab for DSO096

Post Reply
rabati
Posts: 3
Joined: Sat Oct 12, 2013 3:35 pm

jyeLab for DSO096

Post by rabati »

Hello, just bought the oscilloscope that runs very well.

I have a problem with the software, I'm using Windows XT:
- I installed the drivers from silabs website
- when I connect the oscilloscope the driver identifies it on COM3 port, and windows says that all is OK
- I have set speed and other setting as described into your quick User Guide rev03 (38400, 8, 1, ...)

When I run the jyeLab it is not able, opening port at the right speed (34800) to detect the oscilloscope.

Any further suggestion ?

I'm running the software on VmWare under a macintosh but I never had problems on COM with other devices.

Help is appreciated, Thanks.
Attachments
Screen Shot 2013-10-12 at 17.43.25.jpg
Screen Shot 2013-10-12 at 17.43.25.jpg (22.53 KiB) Viewed 19979 times
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: jyeLab for DSO096

Post by jye1 »

Please check the following:

1 ) Main firmware version. It should be 113-09401-050 or later.
2 ) Check 094 baudrate from menu. Set it to match that at jyeLab. 094 baudrate is changeable for firmware version -052 or later.
rabati
Posts: 3
Joined: Sat Oct 12, 2013 3:35 pm

Re: jyeLab for DSO096

Post by rabati »

Thanks for the answer.

The firmware is 09601-11 (is the last release).
I have the same baudrate in Windows COM settings and in JYELAB but I don't know how to set it up into the oscilloscope.

Cheers, Roberto
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: jyeLab for DSO096

Post by jye1 »

I am sorry. I overlooked the title. jyeLab does not support 096 yet. It only supports 094.
rabati
Posts: 3
Joined: Sat Oct 12, 2013 3:35 pm

Re: jyeLab for DSO096

Post by rabati »

Hi, you told that

" jyeLab does not support 096 yet. It only supports 094."

So when it will be supported ?
My documentation says that jyeLab is supported !

Cheers
jye1
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: jyeLab for DSO096

Post by jye1 »

It might take quite a while. I'm sorry we have been pretty busy with other products. jyeLab was developed after 096 so it takes some extra efforts to make 096 work with jyeLab. We want to do it but only when we find a time slot.

Could you please let me know which document said 096 was supported by jyeLab?
Post Reply