jyeLab for DSO096
Posted: Sat Oct 12, 2013 3:44 pm
Hello, just bought the oscilloscope that runs very well.
I have a problem with the software, I'm using Windows XT:
- I installed the drivers from silabs website
- when I connect the oscilloscope the driver identifies it on COM3 port, and windows says that all is OK
- I have set speed and other setting as described into your quick User Guide rev03 (38400, 8, 1, ...)
When I run the jyeLab it is not able, opening port at the right speed (34800) to detect the oscilloscope.
Any further suggestion ?
I'm running the software on VmWare under a macintosh but I never had problems on COM with other devices.
Help is appreciated, Thanks.
I have a problem with the software, I'm using Windows XT:
- I installed the drivers from silabs website
- when I connect the oscilloscope the driver identifies it on COM3 port, and windows says that all is OK
- I have set speed and other setting as described into your quick User Guide rev03 (38400, 8, 1, ...)
When I run the jyeLab it is not able, opening port at the right speed (34800) to detect the oscilloscope.
Any further suggestion ?
I'm running the software on VmWare under a macintosh but I never had problems on COM with other devices.
Help is appreciated, Thanks.