JYE Tech Forum

Did you have all jumpers on the back side of analog PCB open? If you did SW4 should turn scope off when battery is used.

When upgraded from old firmware (earlier than version -100) activation is required. Please enter activation code "7030" by following these steps: 1 ) Install new firmware if you have older ones (i.e. version 113-15001-064 or earlier) 2 ) Boot the scope to its normal working state (where gr...

What kind of power supply you used?

JYETech would be happy to provide 3 free DSO112A's to users who can help to test this software. Anyone interested can contact us at jyetech@163.com.

@ KillerM :

We PM you a few weeks ago. If you are still interest in receiving a free DSO112A to test the software please contact us. Thanks.

The changes in -215 include 1 ) added a "CommandDone" frame which is sent under the following cases --- Exit USB scope mode --- After execution of SetParam command --- After execution of SetMode command The CommandDone frame is in format E6 04 00 00 which frame ID being 0xE6. 2 ) Modified ...

Serial output of data is through a Uart port at the right border of the main board (the pins marked TX and RX), not through USB. A Uart-USB converter is required to send the data to PC. The output data is ASCII coded. They are plain text. The simplest way to display the data is capture them with any...

Please see attachment.

You can do checking by 1 ) apply a DC voltage at input and measure V1. V1 should be about 90% of input. Otherwise U1D might be bad. 2 ) Make sure higher gain channel is selected. Check V3. V3 should be twice of V1. If this is not the case the multiplexer U2 might be defective. Before doing this it i...

It looks all voltages were off by about 1.5V. Could that be a measurement issue?

@blixten:

Can you check and post the keypad firmware version? It is displayed at power up with digits like 113-06802-XXX where XXX is the version number.