JYE Tech Forum

Luckily no permanent damage .

Re ; FFFF ,

you will find out within 5 start-ups






look at topic "firmware 110 problems SOLVED !! " for your answer .

Alphaseek , Unfortunately no pictures , but J5 is very straightforward , simply solder a right-angle 2,54 pinheader to it . for the jumpers J1 / J2 i glued a straight 2.54 pin-header on a little piece of 1mm plastic and that on the main-pcb so both the headers are more or less on the same height . i...

new functions in 110 ;

v/div + adj = sending data
v/div + ok =calibration

only when you upgrade to 110 ,
and when you get this message at power up .

110 has some nice new features too .

And working !!

Thanks .

Hi forum , I can not change the levels of v/div and sec/div any more after flashing to version 110 . At the first boot i could change the values down , but not up anymore . At version 64 the unit works fine........... version i have is ; main pcb 00E Analog pcb 00E are there any more points to watch...

U5 icl7660 is widely available

Quickchip is really good for desoldering small packages , using hot air is even better ( but a lot costlier )

keep us updated on your progress

Dave ,

see my post "C5 calibration on new version"

use the settings from the manual , c3 can affect both settings ( 0.1 and 3.3 ) c5 has very low influence.

are you willing to share the 3d files with us ??

i do like the way your enclosure is attached to the Original housing



jan

Nice video !! thanks