I did the reset to default. Still no waveform.
I measure 2,5 volts. Thats OK.
I will send a e-mail about the replacement unit.
Thanks for the help. Appreciated
Search found 4 matches
- Tue Sep 27, 2016 12:36 pm
- Forum: FG085
- Topic: FG085 Out put
- Replies: 8
- Views: 23726
- Tue Sep 13, 2016 5:25 pm
- Forum: FG085
- Topic: FG085 Out put
- Replies: 8
- Views: 23726
Re: FG085 Out put
What do you mean with R13 is opened. I measure voltage over R13. On both sides of the resistor. Same voltage is also at pin7 of U6 I also measure the U6 VCC pins. All receive 5 volts. Are there more methodes to test if U6 is working? Still no signal at R9 or R16 Does it help if I flash the AVR U6 ch...
- Tue Sep 06, 2016 6:09 pm
- Forum: FG085
- Topic: FG085 Out put
- Replies: 8
- Views: 23726
Re: FG085 Out put
Hello, I received in july the FG085. But its not working. I only get a offset as output. But no waveform. I measured on every point i could measure with some help of the schematics. But no wavefront. I used a multimeter and the DSO138. If i change the offset in the software that also chancing at the...
- Wed Jul 27, 2016 9:31 am
- Forum: FG085
- Topic: FG085 Out put
- Replies: 8
- Views: 23726
Re: FG085 Out put
I have the same problem. A couple weeks ago i received the generator from Banggood. The build process was easy. But i dont get a signal out of the machine. If i measure with the multimeter on all pin the power is good. On the output pin i only measure the offset voltage. If I change the offset volta...