Search found 56 matches
- Fri Jun 26, 2020 10:01 am
- Forum: DSO Shell
- Topic: I hope someone can help me.
- Replies: 9
- Views: 4153
Is there anything I need to do after flashing the firmware? I tried a few custom ones and they didn't work. At least with this one (which I've tried in a clone with success), you need to push "OK" at power up the first time to reset default settings. At first, I used the pre-compiled bina...
You need to flash an official firmware older than version 064 (which was the first one that started to check for fakes): https://jyetech.com/firmware-dso-150-shell/ You can also try one of the alternatives to the official firmware that can be found on this forum; for example: https://jyetech.com/for...
- Sat May 16, 2020 10:42 am
- Forum: DSO Shell
- Topic: Alternative firmware to use in an analogue synth?
- Replies: 3
- Views: 5001
... Its FW source code is also available and there's also an open source version with two channel capabilities)... Just to state that, contrarily of what I thought then, the HW of 138 and 138 mini is quite different, so the open source FWs for 138 would need to be modified to suit 138mini (see my c...
- Sat May 16, 2020 10:14 am
- Forum: DSO138mini
- Topic: JP1 & JP2 brought to the edge of the mainboard
- Replies: 0
- Views: 1633
I just wanted to share my solution to implement removable jumpers for JP1 and JP2. As you can see in the attached images, I just used a 2x4 pin header installed in J3, and routed CPU's sides of JP1 and JP2 to the pins in parallel with 3.3V and GND of J3 with thin wires. This way, if I install the ju...
Hello! I just got a DSO138 mini from Banggood. I assume it's genuine because there has been no fake advice on this model, the serial nº on the screen matches the sticker, and the quality is excellent. FW is ver. 111. As I already had a Shell and a "normal" DSO138, I bought this one to do s...